Hang these bleeder bottles from a suspension component or lug stud/bolt and save yourself a whole lot of juggling, balancing, and spills. A really handy tool when bleeding brakes. Just hang the bottle then put your wrench on the bleeder valve and then put the tube end over the bleeder valve. You are ready to bleed and catch all the waste brake fluid. Minimizes mess and spills and allows you to concentrate on bleeding rather than fumbling with the brake fluid. All you have to worry about is opening and closing the bleeder valve.
This kit includes two 500ml (approximately 1 pint) bottles.
This time-saving tool is the perfect accessory for any of our brake bleeders.
Tip: When you are done bleeding each valve, slowly remove the tube from the bleeder valve. By allowing air to enter the tube at the bleeder valve the excess fluid in the tube will run into the waste bottle. That way you will not spill fluid. Keeps you and the brakes nice and clean!
Tip 2: When done bleeding, place the end of the tube over the vent and now you have sealed the unit from spills.
Note: Please dispose of brake fluid properly. Brake fluid is a poison. Do not swallow or get brake fluid in your eyes. Brake fluid can damage the finish on your car. Do not allow brake fluid to contact paint or other finshes on your car.
This product was added to our catalog on Wednesday 13 December, 2006.
